Flow Sample Does Not Reach Collector; Counter Sample Does Not Reach Collector - NEC IP8800/S2400 Series Troubleshooting Manual

3.15.2

Flow Sample Does Not Reach Collector

If problem still persists even after checking
(1) Checking presence/absence of the relay packet
Execute the show interfaces command to check to see if the packet is relayed.
Figure 3-26: Display Example of Port Status
> show interfaces gigabitethernet 1/5
Date 2006/10/24 17:19:34 UTC
NIF1: active
Average:150Mbps/24Gbps
Port5: active up
Time-since-last-status-change:1:47:47
Bandwidth:10000kbps
Peak out:5Mbps at 15:44:36
Output rate:
Input rate:
Flow control send
Flow control receive:off
TPID:8100
>
Note: Confirm that the packet is relayed based on the display at underlined part.
(2) Checking settings of collector
Check to see if settings of the collector used are correct.
3.15.3

Counter Sample Does Not Reach Collector

If problem still persists even after checking
(1) Checking transmission interval of counter sample
Check to see if the transmission interval of the counter sample related to flow statistics is set to 0 in the configuration of
this system. If set to 0, the counter sample data is not sent to the collector.
Figure 3-27: Display Example of Configuration
(config)# show sflow
sflow destination 192.1.1.1 6455
sflow sample 2048
sflow polling-interval 60
!
(config)#
"3.15.1 sFlow Packets Do Not Reach
48-port 10BASE-T/100BASE-TX/1000BASE-T
Peak:200Mbps at 15:44:37
100BASE-TX full(auto)
Average out:5Mbps
Peak in:5Mbps at 15:44:18
4893.5kbps
4893.5kbps
:off
:
"3.15.1 sFlow Packets Do Not Reach
<- 0 must not be set here.
3.
Troubleshooting Functional Failures in Operation
Collector," check the following:
retry:0
0012.e220.ec31
Average in:5Mbps
16.8kpps
16.8kpps
Collector," check the following:
115