Beta 2008 URBAN 125cc Service Manual page 96

1
How to use: the chronometer can be started and stopped in manual and automatic
mode when the instrument is set on "Figure 4A":
• The chronometer can be manually started and stopped by quickly pressing the
start/stop button (only with the motorbike off).
• The chronometer is automatically started when the motorbike starts moving; it
automatically stops about 1 second after stopping the motorbike (the displayed
figure is automatically corrected).
The count will also stop when the motorbike stops after driving (even if manually
started), provided the LAP feature is On.
This figure shows the chronometer and
the count of the time: if the count is still
and reset, all the digits are set to zero
and displayed as in figure 4A.
A blinking "LAP" message means the
chronometer is On and will be displayed
even while viewing the other information
pages.
To set other functions not related to the
chronometer even when the chronometer
is on, proceed as follows.
How to reset the chronometer:
Press SCROLL in figure 4A for more than
2 seconds; this will highlight figure 4,
then again figure 4A, with the time
counted the chronometer on it. Release
SCROLL to reset and stop the
chronometer.
How to quit (turn off) the LAP fi-
gure:
From page 4A, press for 1 to 2 seconds
until page 4 appears again, then release
the button. Press the button quickly again
to go to the next page. The chronometer
keeps working, if On, and LAP will blink.
GB
Fig. 4A
22