Beta 2008 URBAN 125cc Service Manual page 116

3
A
GB
ENGINE OIL AND OIL FILTER URBAN 200
Check
B
Keep the vehicle in an upright position.
Check the oil level through oil level sight
A when the engine is cold. The oil level
must never fall below the sight. If neces-
sary, top up after removing filler cap B.
C
Topping up
Only top up after checking the max level
shown on sight A.
D
Renewal
Always renew the oil when the engine is
hot. To avoid burns, take care not to touch
the engine and the oil.
•Replace the oil when replacing the oil
filter.
• Put the vehicle on its stand.
• Put a container under the engine, right
under the drain plug D.
• Unscrew filler plug B and drain plug D.
• Drain all the oil from the crankcase.
• Close plug D.
• Remove the oil filter cover after unscrew-
ing the three nuts C.
• Remove the oil filter and replace it with
a new one.
• Apply a thin film of engine oil to the
filter cover O-ring before insertion.
• Apply a film of engine oil over the filter
cover O-ring before fitting it.
42