Beta 2008 URBAN 125cc Service Manual page 118

3
ENGINE OIL AND OIL FILTER URBAN125
Check
Keep the vehicle in an upright position.
The engine is cold, check for the pres-
ence of oil.
Topping up
To restore the level, remove cap A and
top up.
Renewal
Always renew the oil when the engine is
hot. To avoid burns, take care not to touch
the engine and the oil.
• Put the vehicle on its stand.
• Extract the two screws D and fastening
E, and then remove protection C.
• Place a container under the engine.
• Unscrew filler plug A and drain plug B.
• Drain all the oil from the crankcase.
• Close plug B.
• Pour in 1000 cc of fresh oil.
• Screw on filler cap A again.
WARNING
Hot oil can cause severe burns.
Note:
the URBANI25 engine contains the rotary
oil filter, which is mounted on the clutch
side of the drive shaft. To replace it,
contact a licensed Betamotor dealer.
Note:
Renew the engine oil after the first 500
km. For the renewal intervals, refer to the
table on page 57. Only use the lubri-
cants recommended on page 37.
IMPORTANT
Dispose of used oil in compliance with
the regulations in force.
GB
B
44
A