Beta 2008 URBAN 125cc Service Manual page 143

B
D
REPLACING THE REAR LIGHT BULB
To replace the back light unit A, proceed
as follows:
• Remove the plate holder as described
in the section, " Removal of body parts "
on page 60.
• Disconnect all electric connections.
• Loosen the two screws B under the fen-
der.
• Pull out the faulty light unit A and replace
it with a new one.
• To fit it all back in, proceed in reverse.
Note:
A
Any replacement lamp must meet the
same specifications as the original ones
(see section, "Light specifications", page
76).
C
REPLACING THE TURN INDICATOR
BULBS
To replace the plate number light,
proceed as follows:
• Loosen the screw C.
• Remove the transparent screen D.
• Pull the faulty light out of the bulb and
replace with a new one.
• To fit it all back in, proceed in reverse.
Note:
Any replacement lamp must meet the
same specifications as the original ones
(see section, "Light specifications", page
76).
69
5
GB