National Instruments Xmath Interactive Control Design Module ICDM User Manual page 120

Using an Xmath GUI Tool
Overview
You can run several demos simultaneously.
Note
© National Instruments Corporation
This appendix describes the basics of using an Xmath GUI tool.
ICDM was developed using the programmable Xmath GUI (Graphical
User Interface). Using a graphical tool such as ICDM is quite different from
using a toolbox that has a traditional command-line user interface.
To see a menu of Programmable GUI examples, enter
Xmath command area. This displays the menu of GUI demos shown in
Figure A-1.
1. Select a demo (for example, Variable Binding).
2. Click OK.
In a few seconds the demo will appear. Your window manager may require
you to position the window(s) generated by the demo—this is done by
dragging the window to the desired location.
A-1 Xmath Interactive Control Design Module
A
from the
guidemo