Backguard Installation; Electrical Connections - DCS RGT-305 Installation Manual

BACKGUARD INSTALLATION

The backguard is located as shown in Fig. 14. Secure
the backguard to the wall behind the range. Specific
instructions for installation of the full backguard or low
backguard can be found packaged with the backguard.
See also page 8, "Planning The Installation" section. A
backguard must be installed when there is less than a
12" clearance between combustibles and the back of
the range (above the cooking surface). See fig. 13.
DCS backguards are sold separately.

ELECTRICAL CONNECTIONS

ELECTRICAL CONNECTIONS
Power Requirements Range:
120 VAC, 60 Hz., single phase
I
RGT-305: 4 Amp. Max.
I
RGT-36: 7 Amp. Max.
I
RGT-48: 13 Amp. Max.
I
Always disconnect electric supply cord from the wall outlet or service
disconnect before servicing this appliance. Observe all governing codes
and ordinances when grounding, in absence of which, observe National
Electrical Code ANSI / NFPA No. 70.
RECOMMENDED GROUNDING METHOD
This appliance is factory equipped with a power supply cord with a
three-prong grounding plug (with polarized parallel blades). It must be
plugged into a mating grounding, type receptacle, connected to a
correctly polarized 120 volt circuit. If the circuit does not have a grounding type receptacle, it is the responsi-
bility and obligation of the installer to have the existing receptacle changed to a properly grounded and
polarized receptacle in accordance with all applicable local codes and ordinances by a qualified electrician. In
the absence of local codes and ordinances, the receptacle replacement shall be in accordance with the National
Electrical Code.
Note:
The third prong should not, under ANY circumstances, be cut or removed.
}
use 15 Amp. circuit
Wall Mount
Full Backguard
(Model #'s BGS-3030,
BGS-3036, BGS-3048)
Wall Mount
Low Backguard
(Model #'s BGS-1230,
BGS-1236, BGS-1248)
Fig. 14
Receptacle Box
Cover Plate
Three
Prong
Plug
Fig. 15
1-5/16"
28-1/8"
10-1/8"
2"
Three Prong
Receptacle
17