Installing Application Software, Ni-Daq, And The Daq Device; Installing The Scxi-1125 Module Into The Scxi Chassis; Connecting The Scxi-1125 In An Scxi Chassis To An E/M Series Daq Device For Multiplexed Scanning; Connecting The Scxi-1125 In A Pxi/Scxi Combination Chassis To An E/M Series Daq Device For Multiplexed Scanning - National Instruments Module SCXI-1125 User Manual

Chapter 1 About the SCXI-1125
Installing Application Software, NI-DAQ, and the
DAQ Device
Refer to the Read Me First: Safety and Radio-Frequency Interference document
Note
before removing equipment covers or connecting or disconnecting any signal wires.

Installing the SCXI-1125 Module into the SCXI Chassis

Connecting the SCXI-1125 in an SCXI Chassis to an E/M Series
DAQ Device for Multiplexed Scanning
Connecting the SCXI-1125 in a PXI/SCXI Combination Chassis to an
E/M Series DAQ Device for Multiplexed Scanning
SCXI-1125 User Manual
Refer to the DAQ Getting Started Guide packaged with the NI-DAQ
software to install your application software, NI-DAQ driver software, and
the DAQ device to which you will connect the SCXI-1125. NI-DAQ 7.0 or
later is required to configure and program the SCXI-1125 module. If you
do not have NI-DAQ 7.0 or later, you can either contact a NI sales
representative to request it on a CD or download the latest NI-DAQ version
from .
ni.com
Refer to the SCXI Quick Start Guide to install your SCXI-1125 module.
Refer to the SCXI Quick Start Guide to install the cable adapter and connect
the SCXI modules to the DAQ device.
If you have already installed the appropriate software, refer to Chapter 3,
Configuring and Testing, to configure the SCXI-1125 module(s).
Refer to the SCXI Quick Start Guide to connect the SCXI modules to the
DAQ device.
If you have already installed the appropriate software, refer to Chapter 3,
Configuring and Testing, to configure the SCXI-1125 module(s).
1-4 ni.com