Developing Your Application In Traditional Ni-Daq (Legacy); Table 5-5. Ni-Daqmx Properties - National Instruments Module SCXI-1125 User Manual

Property
Analog Input»General Properties»
Advanced»Range»High
Analog Input»General Properties»
Advanced»Range»Low
Analog Input»General Properties»
Advanced»Gain and Offset»
Gain Value
Analog Input»Measurement Type
Note This is not a complete list of NI-DAQmx properties and does not include every
property you may need to configure your application. For a complete list of NI-DAQmx
properties and more information on NI-DAQmx properties, refer to your ADE help file.
Developing Your Application in Traditional NI-DAQ
(Legacy)
Note If you are not using an NI ADE, using an NI ADE prior to version 7.0, or are using
an unlicensed copy of an NI ADE, additional dialog boxes from the NI License Manager
appear allowing you to create a task or global channel in unlicensed mode. These messages
continue to appear until you install version 7.0 or later of an NI ADE.
© National Instruments Corporation

Table 5-5. NI-DAQmx Properties

Short Name
AI.Max
AI.Min
AI.Gain
AI.MeasType
This section describes how to configure and use Traditional NI-DAQ
(Legacy) to control the SCXI-1125 in LabVIEW, LabWindows/CVI,
Measurement Studio, and other text-based ADEs. These NI ADEs provide
greater flexibility and access to more settings than MAX, but you can use
ADEs in conjunction with MAX to quickly create a customized
application.
Specifies the upper limit of the
input range.
Specifies the lower limit of the
input range.
Specifies a gain factor to apply to
the signal conditioning portion
of the channel.
Indicates the measurement to take
with the analog input channel.
5-15
Chapter 5 Using the SCXI-1125
Description
SCXI-1125 User Manual