Table of Contents
Advertisement
Chapter 1
About the SCXI-1503
Installing Application Software, NI-DAQ, and the
E/M Series DAQ Device
Refer to the Read Me First: Radio-Frequency Interference document before
Note
removing equipment covers or connecting or disconnecting any signal wires.
Installing the SCXI-1503 Module into the SCXI Chassis
Installing the Terminal Block
Configuring the SCXI System Software
SCXI-1503 User Manual
Refer to the DAQ Getting Started Guide packaged with the NI-DAQ
software to install your application software, NI-DAQ driver software, and
the DAQ device to which you will connect the SCXI-1503. NI-DAQ 8.1 or
later is required to configure and program the SCXI-1503 module. If you
do not have NI-DAQ 8.1 or later, you can either contact an NI sales
representative to request it on a CD or download the latest NI-DAQ version
from
.
ni.com
Refer to the SCXI Quick Start Guide to install your SCXI-1503 module.
Table 1-1 shows the supported SCXI-1503 terminal blocks. Refer to the
SCXI Quick Start Guide and the terminal block installation guide for more
information about the terminal block.
Table 1-1. Supported SCXI-1503 Terminal Blocks
Terminal Block
SCXI-1306
TBX-96
SCXI-1310
Refer to the SCXI Quick Start Guide and the user manuals of the modules
in your application to configure and verify them in software.
CJC Sensor
Yes
No
No
1-4
Measurement Type
Resistive temperature
measurements
Custom signals
ni.com
Advertisement
Table of Contents
