Alert Notification Jumper - SkyLink SA-001S User Instructions

Hide thumbs Also See for SA-001S:

Table of Contents

You can enable or disable the Alert Notification. When it is set to enable, the

Wireless External Alarm will beep when arm or disarm or during the entry/exit

countdown period. When it is set to disable, the Wireless External Alarm will not

beep when arm or disarm or during the entry/exit countdown period. However, the

LED will remain flashing as it is. The Wireless External Alarm will still siren when

it is triggered.

Unplug all the power (batteries and AC adapter) when setup the Alert Notification.

Factory default is set to "Enable". To select, you will see a jumper connector marked

"J1" as shown below. Use a paper clip to remove the jumper connector and

re-locate to the proper posts. Apply the power to the Wireless External Alarm again

after setup the Alert Notification

Alert Notification Jumper (J1)

Mode

Enable

Disable

A LErT NOTIFIcATION JumPEr

Jumper (J1) Setting

Set the connector to top 2

posts (1-2)

Set the connector to bottom 2

posts (2-3)

Table of Contents