SkyLink SW-433 User Manual

Introduction

The Silent Alarm (SW-433) transmit a signal to the Silent
is designed to work with all Alarm, and the appliance that
Skylink sensors that in- has been plugged into the
corporate the rolling code silent alarm will be turned on
technology. This alarm can and off for approximately 15
work with as many as 15 seconds. If a lamp is plugged
different sensors. For into the Silent Alarm, the light
instance, it can work with will flash so that it can notify
the Security System Control the hearing impaired. (or you
may plug in a radio to warn
Panel, Temperature Sen-
sor, Smoke Alarm Sensor, the visually impaired)
Vibration Sensor, Flood
Sensor, Door/Window Sen-
sor are activated. They will
NOTE
Skylink will not be held
liable or responsible for
I f you would like to order Skylink's
any misuse or application
product or have difficulty getting
of this product other than
them to work, please :
for its intended use.
1. visit our website FAQ section at
www.skylinkhome.com , or
2. email us at
support@skylinkhome.com , or
3. call our toll free at 1-800-304-1187
CUSTOMER SERVICE
from Monday to Friday, 9 am to
17 Sheard Avenue, Brampton,
5 pm EST.
Ontario, Canada L6Y 1J3
fax: 1-800-286-1320
Email:support@skylinkhome.com
http://www.skylinkhome.com
P/N. 101A091-001
US Patent 6243000B1
©2005 SKYLINK GROUP

Programming the transmitter and the Silent Alarm

1. In order for the Silent Alarm to recognize different transmitters, they must first be"learned" to the Silent Alarm.
2. Plug in the Silent Alarm to an electrical outlet (its red LED light wi ll go on). Plug in an appliance (i.e. light, radio,
maximum 1200 watts) to the outlet of the Silent Alarm.
3. Turn on the appliance that is plugged into the Silent Alarm. Turn on the Silent Alarm
by pressing the "ON/OFF" button. The appliance should be on after the "ON/OFF"
button is pressed. If you press the "ON/OFF" button again, the appliance will be
turned off.
4. With the Silent Alarm plugged in, press and hold the "SET" button on the unit
(its red LED light will flash). Simultaneously activate the sensor that you want
to program to the silent alarm until the red LED light on the silent alarm stops
flashing indicating it has learned the code.
5. Test the sensor by activating it while the Silent Alarm and the appliance are plugged
in. The appliance will turn on and off for approximately 15 seconds. If the appliance
that you plugged in does not turn on and off, repeat the above procedures .
®
SILENT ALARM
USER'S INSTRUCTIONS
(Model SW-433)

Warranty

If, within one year from date The Remote Control is
of purchase, this product approved by the FCC and
should become defective, it complies with Part 15
due to faulty workmanship of the FCC Rules. Its
or materials, it will be re- operation is subject to the
paired or replaced, without following two conditions :
charge. Proof of purchase 1. This device may not
is required. cause harmful inter-
ference.
2. This device must accept
any interference that
may cause undesired
operation.

FCC

WARNING:
Changes or modifications
to this unit not expressly
approved by the party res-
ponsible of compliance
could void the user's
authority to operate the
equipment.