Table of Contents
Advertisement
PrOgrAmmINg – ErAsE rEmOTE Or sENsOr Or cONTrOL
PANEL FrOm ThE WIrELEss ExTErNAL ALArm
To erase unwanted remote(s) or sensor(s) or control panel(s) from the Wireless
External Alarm will erase all learned devices from the Wireless External Alarm.
- Press and hold the Learn/Set button on the Wireless External Alarm for
8 seconds.
- While holding the Learn/Set button on the Wireless External Alarm until the
Learn/Set LEDs turn on. You may release the Learn/Set button when the
Learn/Set LED stay on.
- Press and hold the Learn/Set button again on the Wireless External Alarm for
2 seconds until it emits 2 beeps and all the LEDs flash twice. Now you may
release the 'Learn' button.
- All the learned devices have been erased.
PrOgrAmmINg – ALArm sOuNd durATION
User can customize the alarm period from 30 seconds up to 10 minutes. The factory
default of the alarm period is 3 minutes.
- Press and hold the Learn/Set button on the Wireless External Alarm for
5 seconds, you may release the Learn/Set button while all the LEDs turn on.
- While the PWR and Learn/Set LED stay on, press the Learn/Set button once
on the Wireless External Alarm, the LEDs flash once indicating the alarm
period is set to 30 seconds.
- If you would set the other alarm period, continue to press the Learn/Set button.
Refer to the table below for the alarm period. The LEDs will flash corresponding
to the number you pressed the Learn/Set button.
1- 30 seconds
2- 60 seconds
3- 3 minutes
4- 5 minutes
5- 10 minutes
- Press and hold the Learn/Set button to confirm your setting. You will hear
2 beeps and the LEDs will flash twice indicating the alarm period is now
programmed to the Wireless External Alarm.
7
Advertisement
Table of Contents
