Test Operating Mode - Datalogic DX6400 Reference Manual

SOFTWARE CONFIGURATION
The Wizard option is advised to low skilled users, since it shows a step by step scanner
configuration. The parameters to be defined are the following:
Barcode selection and definition;
-
Operating mode selection and definition (see sub-paragraphs for further details);
-
Digital Inputs/Outputs configuration;
-
Hardware interface selection;
-
Output data format configuration.
-
After defining the parameter values the following window appears allowing to complete the
reader configuration as follows:
Saving the configuration to disk;
-
Switching to Advanced mode;
-
Sending the configuration to the scanner.
-

Test Operating Mode

This operating mode causes the reader to be continuously activated allowing to verify its
reading features and its reading position with respect to the barcode. For this reason, it is
particularly advised during the installation phase of the reader.
After 100 scan, the values relative to an internal counter and the decoded code are displayed
and transmitted on the serial interface. The counter reports the percentage of good reads of
the label.
Figure 55 - Genius™ Wizard Closing Window
Figure 56 - Test Mode Selection
3
41