Test Operating Mode - Datalogic DS6300 Reference Manual

Hide thumbs Also See for DS6300:

Table of Contents

The Wizard option is advised to low skilled users, since it shows a step by step scanner

configuration. The parameters to be defined are the following:

Barcode selection and definition;

Operating mode selection and definition (see par. 3.2.1, 3.2.2, 3.2.3 for further details);

Digital Inputs/Outputs configuration;

Hardware interface selection;

Output data format configuration.

After defining the parameter values the following window appears allowing to complete the

reader configuration as follows:

Saving the configuration to disk;

Switching to Advanced mode;

Sending the configuration to the scanner.

3.2.1

Test Operating Mode

This operating mode causes the reader to be continuously activated allowing to verify its

reading features and its reading position with respect to the barcode. For this reason, it is

particularly advised during the installation phase of the reader.

After 100 scan, the values relative to an internal counter and the decoded code are displayed

and transmitted on the serial interface. The counter reports the percentage of good reads of

the label.

Figure 54 - Genius™ Wizard Closing Window

Figure 55 - Test Mode Selection

DS6300

Table of Contents