Mechanical Mounting; Mounting The Scanner - Datalogic DX6400 Reference Manual

INSTALLATION

2.2 MECHANICAL MOUNTING

2.2.1 Mounting the Scanner

The DX6400/DX6500 reader can be positioned and installed in the best way possible as a
result of the Step-a-Head™ feature. Thanks to the separation between Head and Base, you
can modify the orientation of the decoder base, and therefore display-keypad and connector
panels, while keeping the optic head in the correct reading position. The reading head and
the decoder base can be rotated independently from each other allowing the installation even
in the most critical locations.
To rotate the head follow the given procedure:
1. detach the head from the base by unscrewing the four fixing screws;
2. rotate the head in the desired position;
3. loosen but don't remove the two screws on top of the head;
4. affix the head onto the base carefully aligning the four fixing screws and progressively
tightening them about half-way;
5. completely tighten the two screws on top of the head;
6. completely tighten the four fixing screws.
Head Screws
Figure 5 - Step-A-Head™ Feature
Fixing S crew
(4)
2
5