Test Operating Mode - Datalogic DX6400 Reference Manual

3
After defining the parameter values the following window appears allowing to complete the
reader configuration as follows:
Saving the configuration to disk;
-
Switching to Advanced mode;
-
Sending the configuration to the scanner.
-

Test Operating Mode

This operating mode is not available when DX6400 works as Slave.
NOTE
This operating mode causes the reader to be continuously activated allowing to verify its
reading features and its reading position with respect to the barcode. For this reason, it is
particularly advised during the installation phase of the reader.
After 100 scan, the values relative to an internal counter and the decoded code are displayed
and transmitted on the serial interface. The counter reports the percentage of good reads of
the label.
44
Figure 53 - Genius™ Wizard Closing Window
Figure 54 - Test Mode Selection
DX6400