Operating Mode; Scan Mode - Datalogic PowerScan PM9500 Series Quick Reference Manual

Operating Mode

Scan Mode

The imager can be set to operate in one of several scan-
ning modes. See the PRG for more information and set-
tings for any of the options:
Trigger Single (Default) —
ning is activated until one of the following occurs:
• a programmable duration
• a label has been read
• the trigger is released
Trigger Hold Multiple —
ning starts and the product scans until the trigger is
released or "maximum scan on time"
ing a label does not disable scanning. Double Read Time-
1
out prevents undesired multiple reads in this mode.
Trigger Pulse Multiple —
released, scanning is activated until programmable dura-
1
tion has elapsed or the trigger has been pulled again to
transition to another state. Double Read Timeout
vents undesired multiple reads while in this mode.
Flashing — The reader flashes
trigger status.
Always On —
Scanning is continually on. If the trigger is pulled, the
reader acts as if it is in Trigger Single (Default) Mode. Dou-
ble Read Timeout
while in this mode.
Stand Mode —
code. Scanning is turned on automatically when an item is
placed in reader's field of view. If the trigger is pulled, the
reader acts as if it is in Single Read mode. Double Read
1
Timeout prevents undesired multiple reads while in this
mode.
1. See the Product Reference Guide (PRG) for more information
10
When the trigger is pulled, scan-
When the trigger is pulled, scan-
When the trigger is pulled and
No trigger pull is required to read a bar code.
1
prevents undesired multiple reads
N
o trigger pull is required to read a bar
1
has elapsed
1
has elapsed. Read-
1
on and off regardless of the
Operating Mode
1
pre-
PowerScan™ PM9500