SMART Board M685ix2 Configuration And User's Manual page 34

C H A P T E R 4
Maintaining your interactive whiteboard system
W A R N I N G
Replace the lamp when the projector displays its lamp life warning message. If you
l
continue to use the projector after this message appears, the lamp can shatter or burst,
scattering glass throughout the projector.
If the lamp shatters or bursts, leave and then ventilate the area.
l
Next do the following:
Avoid touching the glass fragments because they can cause injury.
o
Wash your hands thoroughly if you have come into contact with lamp debris.
o
Thoroughly clean the area around the projector, and discard any edible items placed
o
in that area because they could be contaminated.
Call your authorised SMART reseller for instructions. Do not attempt to replace the
o
lamp.
When replacing the projector lamp:
l
Put the projector into Standby mode and wait 30 minutes for the lamp to cool
o
completely.
Do not remove any screws other than those specified in the lamp replacement
o
instructions.
Wear protective eyewear whilst changing the lamp. Failure to do so can cause
o
injuries including loss of eyesight if the lamp shatters or bursts.
Use only replacement lamps approved by SMART Technologies. Contact your
o
authorised SMART reseller for replacement parts.
Never replace the lamp module with a previously used lamp module.
o
Always handle the fragile lamp module with care to prevent premature lamp failure or
o
exposure to mercury. Use gloves When touching the lamp. Do not touch the lamp
with your fingers.
Recycle or dispose of the lamp module as hazardous waste in accordance with local
o
regulations.
See smarttech.com/compliance
l
documents.
26
for the projector's Material Safety Data Sheets (MSDS)