Installing Server Blades; Before Installing - PRIMERGY BX600 S2 Hardware Manual

Chapter 4 Installing Options

4.2 Installing Server Blades

For this server, even when the power supply of the chassis is turned on, it is possible
to install/remove (hot-swap/hot-plug) server blades.
This section explains how to install/remove server blades.
For details about server blade, refer to "User's Guide" supplied with the server blade.

4.2.1 Before Installing

■ Notes when installing and removing
Server blades can be installed/removed when the main power of the chassis is turned on. In this case
note the following points.
• Always turn off the power of the server blade.
"3.3 Turning Off the Server" (pg.26)
• Check that the system fan unit is operating correctly before installing or removing the blade
server. If it is broken, the blade server cannot be installed/removed during operation.
• Because the heat sink area of the server blade reaches high temperatures, do not touch it
directly after removal.
• Be careful not to pinch fingers or clothes. This may cause injury.
• When removing the server blade or dummy server blade, do not insert your hand into the
server blade slot. Doing so may cause electric shock.
■ Installable server blade
The following server blade can be installed to the chassis.
• BX620 S2 Server Blade
• BX620 S3 Server Blade
36