Storage Menu - PRIMERGY BX600 S2 Hardware Manual

■ Storage menu

Settings related to the CD-ROM drive and floppy disk drive of the client computer to be emulated.
Item
USB CD-ROM
USB Floppy
• USB Floppy submenu
Set the floppy disk drive of the client computer to be emulated.
Item
Floppy Emulation
Mount Floppy Drive
←→
UnMount Floppy
Drive
Save Image To
UFI Command
Block
[for Linux
Installation]
PRIMERGY BX600 S2 Blade Server System Unit Hardware Guide
Specify the CD-ROM drive of the client computer to be emulated.
Note:
Select the server blade to connect the virtual CD-ROM using "USB Switch" in
■
" Control menu" ( pg.78).
Set the floppy disk drive of the client computer to be emulated.
"• USB Floppy submenu" (pg.79)
Setting value
• No Emulation Select the floppy disk drive to be emulated.
• Floppy (A:) The selected floppy disk and floppy disk image are copied to
• Open HDD Image the advanced KVM module memory, and emulated as a
File remote USB floppy of the specified server blade until the
Global Viewer session ends.
Note:
- Mount/unmount the virtual floppy disk drive to the advanced
KVM module.
Note:
- Save the emulated floppy data (data read in the advanced
KVM module) in the floppy disk drive of the client computer
or in the hard disk as a floppy image.
Note:
- Set this to enabled only when Linux is installed via the
advanced KVM module.
Click this item to enable it. After it has been enabled a check
mark is displayed for the item.
Description
Description
• No Emulation: They are not emulated.
• Floppy (A:): Floppy disk drive in A drive is emulated
(Displays the number of drives that the client computer
recognizes).
• Open HDD Image File: Previously saved hard disk images
are emulated.
Performing emulation only does not enable the floppy
disk drive to be used. It is necessary to mount the
floppy disk drive and to select USB Switch.
• Mount Floppy Drive: Mount the virtual floppy disk drive
to the advanced KVM module.
• UnMount Floppy Drive: Unmount the virtual floppy disk
from the advanced KVM module.
Mounting the drive only does not enable the floppy
disk drive to be used. It is necessary to emulate data
and to select USB Switch.
If a virtual floppy disk drive is unmounted without
performing this operation when the emulated floppy
data has been modified, the modified data will not be
saved.
This cannot be selected without emulating floppy
data.
6
79