Turning Off The Server - PRIMERGY BX600 S2 Hardware Manual

Chapter 3 Standard Operations

3.3 Turning Off the Server

• Follow the procedure below to turn off the server. Data can be lost if this procedure is not
followed correctly.
• In the event of smoke or sparks, immediately unplug the power plug from the outlet.
Failure to do so may lead to a fire or electric shock.
1
Exit the OS operating on each server blade.
After exiting the OS the power of the server
blade automatically turns off and the server
blade power LED is lit in amber.
If the server power does not turn off even after
exiting the OS, confirm that the hard disk
access LED is not lit and then press the power
switch of the server blade.
2
Press the main power switch on the front of the chassis.
Press the switch until the main power supply
LED of the chassis turns off.
3
Power off the display and peripheral devices.
26
• Be sure to wait for 10 seconds or longer after server blade shutdown before turning the
server on. If the power is turned on straight after shutdown, it may cause a server error
or failure.
• Wait for 20 seconds before removing the server blade from the chassis or unplugging
the chassis power cable after server blade shutdown.
• Be sure to wait for 10 seconds or longer after shutdown before turning the server on. If
the power is turned on straight after shutdown, it may cause a server error or failure.
• Be sure to wait at least 30 seconds before removing power cables after turning off the
main power.
Power LED
is lit in amber
Server blade power switch
Main power LED
turns off
Main power switch