Installing/Removing Fc Pass-Thru Blades - PRIMERGY BX600 S2 Hardware Manual

4.3.2 Installing/Removing FC Pass-Thru Blades

This section explains how to install/remove FC Pass-Thru Blades (optional).
■ Before installing
●
Notes when installing and removing
FC Pass-Thru Blades can be installed/removed when the main power of the chassis is turned on. In
this case, note the following points.
• When removing the FC Pass-Thru Blades or dummy Switch Blade, do not insert your hand
into the FC Pass-Thru Blades blade slot. Doing so may cause electric shock.
• Before lifting the handle, make sure the FC Pass-Thru Blade is inserted completely to the slot.
●
FC Pass-Thru Blade installation points
[Rear of the chassis]
Network blade slot 4
●
Available FC Pass-Thru Blade
The following shows the type of FC Pass-Thru Blade used for this chassis.
Product name
FC Pass-Thru Blade
Included FC Pass-Thru Blade options
Before installing the FC Pass-Thru Blade, refer to "6.1.3 FC Pass-Thru Blade Specifications"
( and check the included options.
pg.66)
PRIMERGY BX600 S2 Blade Server System Unit Hardware Guide
Model
PG-FCB101
Network blade slot 3
45
4