Daikin OH08-1 Instruction Manual page 98

Remote Controller (Wireless Type)
Heating capacity & Outdoor air temperature
Heating capacity drops as outdoor air temperature lowers. If feeling cold, use another heater at the
same time as this air conditioner.
Hot air is circulated to warm the room. It will take some time from when the air conditioner is first started
until the entire room becomes warm. The internal fan automatically turns at low speed until the air
conditioner reaches a certain temperature on the inside. In this situation, all you can do is wait.
If hot air accumulates on the ceiling and feet are left feeling cold, it is recommended to use a circulator.
For details, contact the place of purchase.
PROGRAM DRY OPERATION (Fig. 5, 6)
The function of this program is to decrease the humidity in your room with the minimum temperature
decrease.
Micro computer automatically determines TEMPERATURE and FAN SPEED.
This system does not go into operation if the room temperature is below 16°C.
〈〈
FOR SYSTEMS WITHOUT COOL/HEAT CHANGEOVER REMOTE CONTROL SWITCH (Fig. 5)
1
2
OPERATION lamp lights up and system starts OPERATION.
ADJUSTMENT
STOPPING THE SYSTEM
3
OPERATION lamp goes off and the system stops OPERATION.
NOTE
Do not turn OFF power immediately after the unit stops. Then, wait no less than 5 minutes. Water is
leaking or there is something else wrong with the unit.
〈〈
FOR SYSTEMS WITH COOL/HEAT CHANGEOVER REMOTE CONTROL SWITCH (Fig. 6)
1
2
3
OPERATION lamp lights up and the system starts.
STOPPING THE SYSTEM
4
OPERATION lamp goes off, and the system stops OPERATION.
NOTE
Do not turn OFF power immediately after the unit stops. Then, wait no less than 5 minutes. Water is
leaking or there is something else wrong with the unit.
MOVEMENT OF THE AIR FLOW FLAP
For the following conditions, micro computer controls the air flow direction so it may be different from the
display.
Operation conditions
Operation mode includes automatic operation.
96
Press OPERATION MODE SELECTOR button several times and select "
DRY OPERATION).
Press ON/OFF button.
Press ON/OFF button again.
Select COOLING OPERATION MODE with the COOL/HEAT CHANGEOVER REMOTE
CONTROL SWITCH.
Press OPERATION MODE SELECTOR button several times and select PROGRAM DRY
" ".
Press ON/OFF button.
Press ON/OFF button once again.
Operation mode
When room temperature is lower than
the set temperature
When operating continuously at horizontal air flow direction
Cooling
When room temperature is higher than
the set temperature
At defrost operation
OH08-1
〉〉
" (PROGRAM
〉〉
Heating
Control Systems