Daikin OH08-1 Instruction Manual page 96

Remote Controller (Wireless Type)
How to put the dry batteries
1. Remove the back cover of the remote controller to the direction pointed by the
arrow mark.
2. Put the batteries
Use two LR03<IEC> dry cell batteries. Put dry batteries correctly to fit their (+) and
(–).
3. Close the cover
When to change batteries
Under normal use, batteries last about a year. However, change them whenever the
indoor unit doesn't respond or responds slowly to commands, or if the display
becomes dark.
[CAUTIONS]
Replace all batteries at the same time, do not use new and old batteries intermixed.
In case the remote controller is not used for a long time remove all batteries in order to prevent liquid
leak of the battery.
IN THE CASE OF CENTRALIZED CONTROL SYSTEM
If the indoor unit is under centralized control, it is necessary to switch the remote controller's setting. In
this case, contact your DAIKIN dealer.
Operation Procedure
Operating procedure varies with heat pump type and straight cooling only type. Contact your Daikin
dealer to confirm your system types.
To protect the unit, turn on the main power switch 6 hours before operation.
If the main power supply is turned off during operation, operation will restart automatically after the
power turns back on again.
COOLING, HEATING, AUTOMATIC AND FAN OPERATION (Fig. 3, 4)
AUTOMATIC OPERATION can be selected only by Heat recovery system.
Cooling only system gives selection of FAN or COOLING OPERATION only.
〈〈
FOR SYSTEMS WITHOUT COOL/HEAT CHANGEOVER REMOTE CONTROL SWITCH (Fig. 3)
1
COOLING OPERATION..................................................."
HEATING OPERATION...................................................."
AUTOMATIC OPERATION .............................................."
FAN OPERATION ............................................................"
On AUTOMATIC OPERATION
In this operation mode, COOL/HEAT changeover is automatically conducted at a present indoor
temperature.
2
OPERATION lamp lights up and the system starts OPERATION.
〈〈
FOR SYSTEMS WITH COOL/HEAT CHANGEOVER REMOTE CONTROL SWITCH (Fig. 4)
1
COOING OPERATION.....................................................Refer to fig. 4-1 (
HEATING OPERATION....................................................Refer to fig. 4-2 (
FAN OPERATION ............................................................Refer to fig. 4-3 (
94
Press OPERATION MODE SELECTOR button several times and select the OPERATION
MODE of your choice as follows.
Press ON/OFF button.
Select OPERATION MODE with the COOL/HEAT CHANGEOVER REMOTE CONTROL
SWITCH as follows.
"
"
"
"
〉〉
, )
, )
)
Control Systems
OH08-1
〉〉