Daikin OH08-1 Instruction Manual page 97

OH08-1
2
OPERATION lamp lights up and the system starts OPERATION.
ADJUSTMENT
For programming TEMPERATURE and FAN SPEED and AIR FLOW DIRECTION, follow the procedure
shown below.
3
DOWN
In case of automatic operation
DOWN
NOTE
The setting is impossible for fan operation.
4
HH, H or L fan speed can be selected.
STOPPING THE SYSTEM
5
OPERATION lamp goes off, and the system stops OPERATION.
NOTE
Do not turn OFF power immediately after the unit stops. Then, wait no less than 5 minutes. Water is
leaking or there is something else wrong with the unit.
[EXPLANATION OF HEATING OPERATION]
DEFROST OPERATION
As the frost on the coil of an outdoor unit increases, heating effect decreases and the system goes into
DEFROST OPERATION.
The fan operation stops and the DEFROST lamp of the indoor unit goes on.
After 6 to 8 minutes (maximum 10 minutes) of DEFROST OPERATION, the system returns to
HEATING OPERATION.
Control Systems
Press ON/OFF button.
Press TEMPERATURE SETTING button and program the setting temperature.
Each time this button is pressed, setting temperature rises 1°C.
UP
Each time this button is pressed, setting temperature lowers 1°C.
Each time this button is pressed, setting temperature shifts to "H" side.
UP
Each time this button is pressed, setting temperature shifts to "L" side.
Setting temperature
Press FAN SPEED CONTROL button.
Press ON/OFF button once again.
Remote Controller (Wireless Type)
H • M
25 23 22
2
°
[ C]
• L
21 19
95