Daikin OH08-1 Instruction Manual page 130

Remote Controller (Wireless Type)
For example.
ON OFF
TEMP
TIME
C
UP
DOWN
FAN
RESERVE CANCEL
hr.
TIMER
hr.
MODE
NOTE
• After the timer is programmed, the display
shows the remaining time.
HOW TO SET MASTER
REMOTE CONTROLLER
(For VRV system)
• When the system is installed as shown
below, it is necessary to designate the
master remote controller.
For Heat pump system
When one outdoor unit is connected with
several indoor units.
Outdoor unit
One of these remote controllers needs
to be designated as the master remote
controller.
128
When the timer is
programmed to stop
the system after 3
hours and start the
system after 4
hours, the system
will stop after 3
hours and then 1
hour later the sys-
tem will start.
Indoor unit
For Heat recovery system
When one BS unit is connected with several
indoor units.
Outdoor unit
BS unit
One of these remote controllers needs
to be designated as the master remote
controller.
• Only the master remote controller can
select HEATING, COOLING or
AUTOMATIC (only Heat recovery system)
OPERATION.
When the indoor unit with master remote
controller is set to "COOL", you can switch
over operation mode between "FAN", "DRY"
and "COOL".
When the indoor unit with master remote con-
troller is set to "HEAT", you can switch over
operation mode between "FAN" and "HEAT".
When the indoor unit with master remote
controller is set to "FAN", you cannot switch
operation mode.
When attempting settings than that
consented above, a "peep" is emitted as a
warning.
Only with Heat recovery system, you can set
the indoor unit to AUTOMATIC. Attempting to
do so, a "peep" will be emitted as a warning.
How to designate the master remote
controller
Operate in the following order.
1 MODE
OH08-1
Indoor unit
3PA63363-25Y-8
Control Systems