Daikin OH08-1 Instruction Manual page 35

OH08-1
The setting temperature range of the remote
controller is 16°C to 32°C.
VRV System
See the operation manual provided with the
air conditioner.
5. OPERATION PROCEDURE
Refer to figure 1 (Note 1)
• Operating procedure varies with heat
pump type and cooling only type. Contact
your Daikin dealer to confirm your system
type.
• To protect the unit, turn on the main power
switch 6 hours before operation.
• If the main power supply is turned off dur-
ing operation, operation will restart auto-
matically after the power turns back on
again.
COOLING, HEATING, AUTOMATIC,
FAN, AND PROGRAM DRY
OPERATION
Operate in the following order.
• AUTOMATIC OPERATION can be
selected only by Heat pump split system or
Heat recovery VRV system.
• For cooling only type, "COOLING", and
"FAN" and "DRY"operation are able to
select.
〈〈 〈〈 〈〈 〈〈FOR SYSTEMS WITHOUT COOL/
HEAT CHANGEOVER REMOTE
CONTROL SWITCH〉〉 〉〉 〉〉 〉〉
Refer to figure 1-1, 2 (Note 2)
OPERATION MODE
1 MODE
SELECTOR
Press OPERATION MODE SELECTOR
button several times and select the
OPERATION MODE of your choice as
follows.
COOLING OPERATION .................... "
HEATING OPERATION ..................... "
Note 1 : page 28, Note 2 : page 28, Note 3 : page 28
Control Systems
AUTOMATIC OPERATION ................ "
• In this operation mode, COOL/HEAT
changeover is automatically conducted.
FAN OPERATION.............................. "
DRY OPERATION ............................. "
• The function of this program is to
decrease the humidity in your room with
the minimum temperature decrease.
• Micro computer automatically
determines TEMPERATURE and FAN
SPEED.
• This system does not go into operation if
the room temperature is below 16°C.
ON OFF
2
ON/OFF
Press ON/OFF button
OPERATION lamp lights up or goes off and
the system starts or stops OPERATION.
NOTE
• Do not turn OFF power immediately after
the unit stops. Then, wait no less than
5 minutes.
Water is leaking or there is something else
wrong with the unit.
〈〈 〈〈 〈〈 〈〈FOR SYSTEMS WITH COOL/HEAT
CHANGEOVER REMOTE CONTROL
SWITCH〉〉 〉〉 〉〉 〉〉
Refer to figure 1-1,3 (Note 3)
OPERATION MODE
1
SELECTOR
(1) Select OPERATION MODE with the
COOL/HEAT CHANGEOVER REMOTE
CONTROL SWITCH as follows.
COOLING OPERATION .............."
HEATING OPERATION ..............."
"
"
Remote Controller (Wireless Type)
"
"
"
"
"
3PA63363-24W-5
2
33