REMOTE CONTROLLER LOSS PREVENTION WITH BALL CHAIN (OPTIONAL) Remote controller Screw Wall attachment screw Ball chain (350mm) Holder Support Installation Match the ring at the end of the ball chain with the screw hole on the back of the remote controller and secure it with the screw.
Page 7
OPERATING GUIDE 1. Transmission source • The source where the signal will be transmitted. 2. Signal transmission indication • Blink to confirm that the last setting has been transmitted to the unit. 3. “ON/OFF” Button • Press once to start the air conditioner unit. •...
Page 8
7. Powerful & Powerful+ function • Press for fast cooling or heating operation. • Fan speed turn to maximum speed. • Press again for smart cooling or heating operation. • Fan speed turn to maximum speed and louver will be adjusted as according to the judgement of sense function.
13. Temperature setting • To set the desired room temperature, press the button to increase or decrease the set temperature. • The temperature setting range is from 16°C to 30°C (Optional setting 20°C to 30°C). • Press both buttons simultaneously to toggle from °C to °F setting. 14.
FAULT DIAGNOSIS (For Inverter only) FAULT DIAGNOSIS BY REMOTE CONTROLLER The temperature display sections indicate corresponding codes. When the ON TIMER CANCEL button or OFF TIMER CANCEL button is held down for 5 seconds, a “ ” indication flashes on the temperature display section. ON/OFF TEMP POWERFUL...