Daikin OH08-1 Instruction Manual page 114

Remote Controller (Wireless Type)
A. UP AND DOWN DIRECTION
• The movable limit of the flap is change-
able. Contact your Daikin dealer for
details.
Press the AIR FLOW DIRECTION
ADJUST button to select the air direc-
tion as shown below.
DISPLAY appears and the
air flow direction continu-
ously varies. (Automatic
swing setting)
Press AIR FLOW DIREC-
TION ADJUST button to
select the air direction of
your choice.
DISPLAY vanishes the air
flow direction is fixed
(Fixed air flow direction
setting).
MOVEMENT OF THE AIR FLOW FLAP
For the following conditions, micro computer
controls the air flow direction so it may be
different from the display.
Operation
Cooling
mode
• When room
temperature
is lower than
the set tem-
Operation
perature
condition
• When operating continuously
at horizontal air flow direction
NOTE
• If you try cooling or programmed drying,
while the flaps are facing downward, air
flow direction may change unexpectedly.
There is nothing wrong with the equip-
ment. This serves to prevent dew formed
112
on parts in the air discharge outlet from
dripping.
• Operation mode includes automatic
operation.
B. LEFT AND RIGHT DIRECTION
• Adjusting air flow direction in the left and
right direction. (Refer to Fig. 1)
NOTE
• Only make adjustments after you have
stopped the air flow direction swing in a
position.
• Stop flaps from swinging before trying to
angle them. Working while the flaps are
moving may get your fingers pinched.
PROGRAM TIMER OPERAT ION
Operate in the following order.
• The timer is operated in the following two
ways.
Programming the stop time (
.... The system stops
operating after the set time has elapsed.
Programming the start time (
.... The system starts
operating after the set time has elapsed.
• The timer can be programmed a maximum
of 72 hours.
• The start and the stop time can be simulta-
Heating
neously programmed.
• When room
temperature
1
is higher than
the set tem-
Press the TIMER MODE START/STOP
perature
button several times and select the
• At defrost
mode on the display.
operation
The display flashes.
For setting the timer stop .... "
For setting the timer start .... "
TIMER MODE START/
TIMER
STOP
C: 3PA63363-21T-7
OH08-1
)
)
"
"
Control Systems