Using The Handset As An Alarm Clock; Restoring The Handset Default; Settings; Base Station Settings - Siemens Gigaset E365 Manual

Base station settings

u
Battery warning tone: The battery
requires charging.
You cannot deactivate the confirmation
tone for placing the handset in the
base station.
Activating/deactivating advisory tones
¢
Audio Settings
§Menu§
¢
Advisory Tones
Setting the battery warning tone
¢
Audio Settings
§§Menu§
¢ ¢
Battery Low
¢
During Call
§OK§
The battery warning tone is activated or
deactivated or sounds during a call.
Using the handset as an
alarm clock
Activating/deactivating the alarm clock
Requirement:
The time is set (see page 11).
¢
Alarm Clock
§Menu§
¢
(‰ = on)
§OK§
After you activate the alarm clock, the
menu for setting the wake up time opens
automatically.
If the alarm clock is set, the wake up time
appears with the l icon in the display.
Setting the wake up time
¢
Alarm Clock
§Menu§
¢
Wakeup time
¢
Enter wake up time
When the alarm clock rings...
Press the display key
deactivate the alarm clock for 24 hours.
If you do not press any key, the alarm clock
switches off after one minute.
34
¢
§OK§
¢
(‰ = on)
§OK§
¢
§OK§
¢
/ /
On Off
§OK§
(‰ = on)
¢ ¢
Activation
OK§
¢
§OK§
¢
§OK§
¢
§OK§
or any key to
§Off§

Restoring the handset default

settings

You can reset any individual settings and
changes that you have made. This will not
affect entries in the directory, calls list, or
SMS lists or the handset's registration on
the base station.
¢ ¢
Settings
§Menu§
¢
Reset Handset
Cancel the reset with a.
Base station settings
The base station settings are carried out
using a registered Gigaset E36 handset.

Changing the system PIN

You have to enter the system PIN when reg-
istering a handset on the base station.
You can change the base's 4-digit default
system PIN ("0000") to a 4-digit PIN known
only to yourself.
¢ ¢
Settings
§Menu§
¢ ¢
System PIN
¢ ¢
New PIN:
§OK§
Should you forget the system PIN, you can
reset the base station to the original
code 0000:
Remove the mains cable from the base
station. Press and hold down the registra-
tion/paging key ù on the base station
while you reconnect the mains cable to
the base station. Only release the key
when you hear a signal tone.
The base station is now reset and the sys-
tem PIN is set to 0000.
¢ ¢
Handset
§OK§ §OK§
¢
§OK§
¢ ¢
Base
§OK§ §OK§
¢ ¢
PIN:
§OK§ §OK§