Setting The North Position - American Dynamics SpeedDome Ultra VII Operator's Manual

Setting the North Position

Direction Indicators permit you to understand the approximate pointing position of the dome
to an established reference point. This reference point is called "North" and may correspond
to magnetic north (if it is known) or some other landmark or fixture. When the dome is
initially installed, "North" defaults to a pre-defined position (0° pan/tilt). You may program
the "North" position to be any point along the dome's pan axis (also called azimuth).
For more information about Direction Indicators, see Chapter 5.
Programming the North Position
1. Select Alarms/Areas/Home/Presets/PZ from the Dome Configuration Menu.
2. Select Set North Position.
The Set North Position screen appears:
3. Point the dome to the new North position. When satisfied with the view, save the setting,
or cancel the change.
4. The Alarms/Areas/Home/Presets/PZ screen appears. Select Exit. The Dome
Configuration Menu appears. Continue with What To Do Next on page 4-20.
Configuring Alarms, Areas, Home, Privacy Settings, and Presets
SET NORTH POSITION
PAN to new north position
ZOOM to mark north position
FOCUS quits w/o changing
4-9