American Dynamics SpeedDome Ultra VII Operator's Manual page 50

Removing or Hiding Privacy Zones
If you made an error during programming or no longer require Privacy Zones, individual
zones or all Privacy Zones may be deleted. To temporarily remove the Privacy Zones, you
may disable their appearance by changing the Hide All Zones setting to Yes.
To delete individual Privacy Zones, you must adjust the position of the arrows to the area of
the screen where the zone is recognized by the firmware. If multiple Privacy Zones are close
together or overlap, the arrows blink, indicating that the selection is not allowed. Figure 4-4
illustrates Privacy Zones that are close together.
Figure 4-4: Deleting Privacy Zones – Invalid Selection
Three Privacy Zones are illustrated. Zones 1 and 2 are overlapping. Zone 1 and 3 are in close
proximity. In this situation, the arrows blink because the target area is the same distance from
all three zones.
To ensure that the correct Privacy Zone is deleted, place the arrows clearly in the zone you
want to delete. Figure 4-5 illustrates a valid selection.
Figure 4-5: Deleting Privacy Zone – Valid Selection
By moving to the left, the arrows stop blinking when the target area enters Zone 1. Pressing
Zoom allows you to delete Zone 1. If you do not want to delete the zone, press Focus.
4-16
Zone 2
Zone 1
Navigate to zone
Zone 3
ZOOM to delete zone
FOCUS quits w/o changing
Zone 1
Navigate to zone
ZOOM to delete zone
FOCUS quits w/o changing
Zone 2
Zone 3
SpeedDome Ultra VII Operator's Manual
Arrows blink to
indicate this is an
invalid selection.
Arrows stop blinking
indicating this is a
valid selection.