American Dynamics SpeedDome Ultra VII Operator's Manual page 80

Command Summary
The following table lists the commands to operate the configuration utility when the dome is
installed in a SensorNet or RS-422 environment.
If you want to ...
Start the configuration utility.
Move the highlight bar on the active menu.
Select the highlighted item on the active menu.
Increase the value of the selected setting. For example, Red or
Blue white balance values.
Decrease the value of the selected field. For example, Red or
Blue white balance values.
Display the next choice for the setting. For example,
Maximum Zoom setting.
Display the previous choice for the setting. For example,
Maximum Zoom setting.
Save changes and exit the utility from any screen.
Manually activate or deactivate IR mode.
Setting Names / Working with Passwords
When setting names or entering password information, the screen displays the available
characters in the selected languages. In these situations, the following commands are used:
If you want to ...
Move the highlight left or right in the character field.
Move the highlight up or down in the character field.
Select the highlighted character in the character field.
Move the cursor to the right of the current character in the
name or password.
Move the cursor to the left of the current character in the
name.
A-2
Use ...
Press and hold Iris Open,
press and hold a Focus
button, then press Zoom
Out
Pan/Tilt
Focus
Zoom In
Zoom Out
Zoom In
Zoom Out
Iris Close, then Focus
Press and hold Iris Open,
press and hold Focus
Far, then press Focus
Near
Use ...
Pan
Tilt
Focus
Zoom In
Zoom Out
SpeedDome Ultra VII Operator's Manual