Installing The Battery In The Computer; Inserting The Computer Into The Handlebar Bracket - VDO MC 2.0 WL Instruction Manual

DE ENG FR IT ES
Step 5 Guide the cable ties through the slot in the handlebar bracket,
place around the handlebars or the stem and pull (do not pull tight
just yet).

5.2 Installing the battery in the computer

Your VDO computer comes without battery built in.
Before you start, please insert battery.
Step 1 Open the battery compartment lid with a coin.
Step 2 Place the battery in the computer casing with the +terminal
pointing up.
Step 3 Make sure that the battery does not tilt.
Step 4 Ensure that the rubber seal lies flat on the battery
compartment lid.

5.3 Inserting the computer into the handlebar bracket

The VDO twist-click system securely connects the computer to the
handlebar bracket.
Step 1 Place the computer into the bracket in a 10 o'clock position.
Step 2 Twist the computer to the right until reaching the 12 o'clock
position and click it into the bracket system.
58 MC 2.0 WL
NL PL
VDO CYCLECOMPUTING
Step 6 If fitting to handlebars: align the computer angle to achieve
optimum readability. now pull the cable ties tight. Snip off protruding
ends with clippers.
Step 5 Insert the battery compartment lid into the opening and use
a coin to turn it to the right as far as it will go (approx. ⅓ turn).
Step 6 After inserting the battery, the computer will start the language
select-mode. See chapter 6.1
TIP for changing batteries: VDO recommends changing the battery
annually. Buy a new battery in good time to ensure the wireless
transmission works perfectly. When the battery is changed,
all settings and all trip totals are saved.
Step 3 To remove the computer, twist it to the left
(do not push or pull).
How to remember: Rigid to the Right, Loose to the Left
>>> P07
>>> P08