Setting The Beeper - VDO MC 2.0 WL Instruction Manual

DE ENG FR IT ES
ALTI DOWn--ALTI DOWn 1 or 2 is shown on the
display.
Press ALTI A
Press in confirmation.
M
ALTI DOWn 1--SET METEr or FEET appears on the display.
The first digit of the altitude reading flashes.
Press ALTI A to reduce the value or
Once you have set the correct value, press
The second digit flashes.
Press ALTI A to reduce the value or
Once you have set the correct value, press
Continue the setting process until all digits have been set.

6.15 Setting the beeper

This area enables you to switch the heart rate warning beeper on or
off. If the current heart rate is below the lower limit set or above the
upper limit set, the beeper will beep.
Process:
Press and hold M for three seconds. SETTInGS--OPEn? flashes.
LAnGUAGE---SELECT---appears on the display.
72 MC 2.0 WL
NL PL
or P to make a selection.
P to increase it.
M to confirm your setting.
P to increase it.
M to confirm your setting.
VDO CYCLECOMPUTING
ALTI DOWn 1--SET OK?
Press M in confirmation.
The MC 2.0 confirms by displaying ALTI DOWn 1--SET DOnE.
To exit settings mode, press and hold the
SETTInGS--CLOSE? flashes. The MC 2.0 switches back to function mode.
Press ALTI A
Press M in confirmation.
C button for three seconds.
or P to scroll to BEEPEr---SET---.