Change Projector Address; Change Baud Rate - Barco R9002370 Owner's Manual

Service Mode

Change Projector Address

Every projector requires an individual address between 0 and 255.
This address can be software installed.
To change the address, use the arrow keys to highlight CHANGE PROJECTOR ADDRESS and then press ENTER.
The Change Projector Address menu will be displayed and the actual current address will be displayed.
The first digit is highlighted. Select the individual digits using the arrow keys. Reprogram with the digit keys on the RCU.
Press ENTER to confirm. Press EXIT to return to the PROJECTOR SETUP menu.

Change Baud Rate

The communication speed between projector and computer has 8 possible speeds. The baud rate can be setup through software.
Highlight CHANGE BAUD RATE using the arrow keys and then press ENTER to display the BAUDRATE selection menu.
The following baud rates are available :
- 9600
- 4800
- 2400
- 1200
- 600
- 300
- 150
- 110
The current baud rate will be highlighted in the menu. To change the baud rate, use the arrow keys to select the desired baud
rate and press ENTER to accept this baud rate.
Pressing EXIT in this menu returns to PROJECTOR SETUP menu.
7 - 4 ___________________________________________________________________________________ R5975809 BARCO CINE 6
PROJECTOR SET-UP
IDENTIFICATION
TOTAL RUN TIME
CHANGE PASSWORD
CHANGE LANGUAGE
CHANGE PROJECTOR ADDRESS
CHANGE BAUDRATE
POWERUP MODE : Standby
COMMON ADDRESS : 0
BARCO LOGO
or
Select with
then <ENTER>
<EXIT> to return
CHANGE PROJECTOR ADDRESS
PROJECTOR ADDRESS
Enter new projector
address :
0 0 0
Use and
and reprogram
with numeric keys
Highest address is 255
<ENTER> to confirm
<EXIT> to return
PROJECTOR SET-UP
IDENTIFICATION
TOTAL RUN TIME
CHANGE PASSWORD
CHANGE LANGUAGE
CHANGE BAUDRATE
POWERUP MODE : Standby
COMMON ADDRESS : 0
BARCO LOGO
or
Select with
then <ENTER>
<EXIT> to return
CHANGE PROJECTOR
ADDRESS
to select,
Projector address will
be changed to 000
<ENTER> to confirm
<EXIT> to cancel
BAUDRATE
Select new baudrate :
9600 4800
2400 1200
600 300
150 110
Select with arrow keys ;
<ENTER>to accept
<EXIT> to return