Convert Vent Outlet (If Necessary); Convert For Co-Linear Applications (Rear Outlet Only) (If Necessary) - Valor MADRONA MF28JN Installation & Owner's Manual

Convert Vent Outlet (if necessary)

If the appliance is to be vented from the top, it is ready
for vent installation once the engine is on the casting
base.
If the appliance is to be vented from the rear, it must be
converted. Follow these simple steps:
1. Remove the following parts in this order:
a) Dura-Vent collar, gasket and intake plate from
the top of the appliance (22 screws of the intake
plate and 2 rear screws of the collar);
b) Exhaust collar (8 screws).
NOTE: The gaskets are glued to the engine or
the intake plate; it is not necessary to separate
them from the parts they are attached to.
However, if they need to be manipulated, BE
CAREFUL not to damage them because their
material is fragile.
2. Re-install through the vent opening at the rear of the
fi rebox in the reverse order in which you took the
parts out.
Convert for Co-linear Applications (Rear
Outlet ONLY) (if necessary)
For conversion of rear outlet collar to co-linear
(two 3-inch pipes) rear venting, refer to instructions
packaged with the 556CLA Co-linear Adapter.
NOTE: Co-linear venting may only be installed into
solid-fuel burning fi replaces and chimneys.
Installation
QUALIFIED
INSTALLER
29 29