Valor MADRONA MF28JN Installation & Owner's Manual page 7

To refi t the window:
1. Place it on its frame and hold it in place while
pushing and turning its fastening studs 90 degrees.
x 4
2. Pull out the top and bottom of the window and
release it to insure the springs return it.
3. Apply fi rm hand pressure around the window frame
to ensure the window is sealed tight against the
fi rebox.
DANGER
!
The window unit must be correctly installed,
fastened and sealed after servicing or serious
bodily injury and/or damage to the appliance
may result.
To ensure a safe operation:
• Double-check that the bottom of the window
frame is correctly installed in the bottom
support railing;
• Verify that the levers are hooked properly to
the window tabs then;
• Pull out the top of the window and release it
to insure the springs return it;
• Ensure the window is sealed before operation.
WARNING
!
Failure to install the window correctly can
leak carbon monoxide, affect the performance
of the fi replace, damage components, cause
overheating resulting in dangerous conditions.
Damage caused by incorrect window installa-
tion is not covered by the Valor warranty.
Owner's Information
4. If the Hot Glass Warning plate has been removed
from the front lower corner of the window,
reinstall it by sliding it between the glass and
the frame as indicated.
Hot Glass Warning Plate
5. Traditional arched or square stoves MFCS01 and
MFCS02: Re-hook the cast front.
Contemporary stove MFCS04:
a) Re-install the upper side columns on each side
of the window fi tting the bottom fi rst and then
pushing in squarely sliding the spring clips on the
inside edge of the side panels.
b) Re-insert the concrete cast shelf between the
upper and lower columns. Close the access door
if opened.
c) Re-hook the window frame cover to the window's
spring-loaded top bolts.
6. Traditional arched stoves MFCS01 and MFCS02:
Re-install the barrier screen by inserting fi rst the top
clip in the arch of the front and then pushing on the
side of the screen so that the clips snap into place.
Contemporary stove MFCS04: Re-install the
barrier screen by hooking fi rst the lower brackets
to the inside edge of the concrete shelf and then
pushing the screen against the stove so the upper
clips snap on the upper side columns.
Cleaning the Stove Casing
DO NOT TOUCH THE STOVE WHILE IT IS
HOT! Let the stove cool first before cleaning it.
Barrier screens
FOR SAFETY PURPOSE, ensure the barrier
screen is re-installed on the stove front after
maintenance.
The barrier screens can be brushed clean.
Cast iron stove body
The matte cast iron stove body can be brushed clean.
The enameled cast iron stove body can be cleaned with
mild soap and water then dried with a lint-free soft cloth.
OWNER'S
INFORMATION
WARNING
!
WARNING
!
7 7