Checking Pilot And Burner Flames; Replacing Batteries; Using Handset Wall Holder; Touching Up Paint - Valor MADRONA MF28JN Installation & Owner's Manual

OWNER'S
INFORMATION
Cast concrete stove body
Dust down the surface regularly with a soft brush and
occasionally follow up with a wipe over with a wet cloth.
A sealer has been applied to the concrete surface, no
cleaning agents nor polishes should be used. In case
of an accidental spill, soak up the liquid IMMEDIATELY
with a dry cloth and follow up with a wipe down with a
wet cloth.
Logs and burner
Dust can be brushed from the ceramic logs and fi rebox
walls after removing the front unit and opening the win-
dow. Dust can also be removed from the burner using
a soft brush after removing the ceramic logs. When
cleaning, make sure that no particles are brushed into
the slots of the burner.

Checking Pilot and Burner Flames

A periodic check of the pilot and burner fl ames should
be made. Check after the fi re has been on for at least
30 minutes. The pilot fl ame must cover the tip of the
thermocouple probe. The main burner fl ame pattern will
vary from appliance to appliance depending on the type
of installation and climatic conditions.
Correct Flame Picture
MF28LSK—Traditionnal Log Set
MF28DWK—Driftwood Kit
Pilot Flame can be seen
between left front and top logs
8 8
Owner's Information
The appliance area must always be kept clear and
free from combustible materials, gasoline and other
fl ammable vapors and liquids.
Inspect the vent terminal outdoors regularly to make
sure that snow, trees, bushes, leaves, or other objects
do not obstruct it.
Examine the vent system and terminal regularly. We
recommend annually.

Replacing Batteries

DO NOT ATTEMPT TO CHANGE THE BATTER-
IES WHILE THE FIREPLACE IS STILL HOT! Let
the fi replace cool fi rst before touching it.
DO NOT USE a screwdriver or other metallic
object to remove the batteries from the battery box
or the handset! This could cause a short circuit.
Low battery signal: see page 14.
BEFORE changing the batteries, turn off the valve
using the switch's On/Off button.
The appliance uses four 1.5 V AA alkaline batteries
for its remote control receiver and one 9 V alkaline
battery for its handset. Batteries should last one to two
seasons, depending on usage. Removing the batteries
in the off-season will extend the battery life. Should
the batteries lose power, the control may be operated
by manually turning the control knob at the valve or by
turning off the valve at the switch.
To replace the batteries in the remote control
receiver:
1. The receiver is located to the left of the valve and
it is clipped to the casting's cross beam. Unclip the
receiver from the cross beam.
2. Slide and remove the receiver cover.
3. Replace the batteries with 4 AA alkaline batteries.
4. Replace the cover.
5. Clip the receiver back to the cross beam.

Using Handset Wall Holder

Your fi replace equipment includes a wall
holder to store the handset. If it hasn't be
installed, refer to the instructions further
on in this manual for the installation.
Pilot
fl ame

Touching Up Paint

Thermocouple
probe must be
Thermocouple
in flame If you need to touch up the paint on your matte cast
probe must be
unit MFCS01, use the Stove Bright by Forrest 1990
in fl ame
Satin Black spray paint. Please note that it may be
necessary to spray the entire cast piece.
WARNING
!
CAUTION