Power Switch - HP EliteDesk 705 G2 Small Form Factor Maintenance And Service Manual

Power switch

The power switch is attached to the left, front of the chassis.
1. Prepare the computer for disassembly
2. Remove the access panel
3. Remove the front bezel
4. Rotate the drive cage to its upright position.
5. From the inside of the front of the chassis, press the tab at the top of the power switch (1) and push the
top of the power switch away from the front of the chassis (2).
6. Remove the cable from the clips built into the bottom of the chassis, then and disconnect the power
switch cable from the system board connector labeled PB/LED.
7. Remove the power switch assembly from the inside of the computer.
(Preparation for disassembly on page
(Access panel on page
(Front bezel on page 20).
20).
19).
Power switch 53