Installing A Secondary 3.5-Inch Hard Drive - HP EliteDesk 705 G2 Small Form Factor Maintenance And Service Manual

Installing a secondary 3.5-inch hard drive

1. Prepare the computer for disassembly
2. Remove the access panel
3. Install four silver 6-32 mounting screws on the sides of the drive (two on each side).
NOTE:
primary 3.5-inch hard drive bay. Refer to
the location of the extra mounting screws.
When replacing a drive, transfer the four mounting screws from the old drive to the new drive.
4. Rotate the drive cage to its upright position.
40 Chapter 4 Removal and replacement procedures – small form factor (SFF) chassis
(Access panel on page
HP has supplied four extra silver 6-32 mounting screws installed on the chassis next to the
(Preparation for disassembly on page
20).
Installing and Removing Drives on page 32
19).
for an illustration of