Removing A Secondary 3.5-Inch Hard Drive - HP EliteDesk 705 G2 Small Form Factor Maintenance And Service Manual

Removing a secondary 3.5-inch hard drive

1. Prepare the computer for disassembly
2. Remove the access panel
3. Rotate the drive cage to its upright position.
4. Disconnect the power cable (1) and data cable (2) from the rear of the hard drive. Press the latch on the
side of the drive cage (3), and then slide the drive out of the drive bay (4).
5. If you are installing a new drive, refer to
are not installing a new drive, rotate the drive cage down and replace the access panel.
(Preparation for disassembly on page
(Access panel on page 20).
Installing a secondary 3.5-inch hard drive on page
19).
40. If you
Drives 39