DFI K8M800 INFINITY User Manual page 36

2
Hardware Installation
2.5.6 IEEE 1394
1394_1
1 0
2
1394_2
9
1
The system board is equipped with an onboard IEEE 1394 port at
location CN6 (IEEE 1394_1) of the system board.
It is also equipped with an IEEE 1394 connector at location J9
(1394_2) for connecting an additional 1394 device. Your 1394 port
may come mounted on a card-edge bracket. Install the card-edge
bracket to the system chassis then insert the connector that is
attached to the 1394 port cable to J9. Make sure pin 1 of the
cable connector is aligned with pin 1 of the J9. You can now connect
an IEEE 1394 device to the port.
BIOS Setting
Enable or disable the onboard 1394 in the Integrated Peripherals
submenu ("VIA OnChip PCI Device" section) of the BIOS. Refer to
chapter 3 for more information.
36