DFI K8M800 INFINITY User Manual page 63

3.1.3.1 AGP & P2P Bridge Control
Move the cursor to this field and press <Enter>. The following
screen will appear.
The settings on the screen are for reference only. Your version may not be identical
to this one.
AGP Aperture Size
This field is relevant to the memory-mapped graphics data of the
AGP card installed in your system. Leave this in its default setting.
AGP 2.0 Mode
This field allows you to select the AGP mode (data transfer rate) that
your AGP card supports to enable enhanced graphics performance with
high bandwidth speeds.
1X provides data transfer rate of up to 264MB/sec.
2X provides data transfer rate of up to 528MB/sec.
4X provides data transfer rate of up to 1066MB/sec.
AGP Driving Control
Set this field to Manual only if there are compatibility problems with
some AGP cards. When set to Manual, you must select a value in the
"AGP Driving Value" field.
3
BIOS Setup
63