Ptz Control Panel; Main Menu - Avtech AVC799B User Manual

3.2.2 PTZ Control Panel

Note: In the PTZ control mode, hot point is supported to move the camera view to the specified point
after a click.
Click on the quick menu bar to display the panel as follows:
/ / /
/
/
/

3.3 Main Menu

Right-click anywhere on the screen to show the main menu as follows, and right-click again to exit.
For details about each menu and its sub-menus, please refer to "5. MAIN MENU' at page 14.
For details about the menu structure, please refer to "APPENDIX 5 MAIN MENU STRUCTURE" at page 59.
Main Menu
Click to enter the camera main menu.
Camera Menu
For details about each camera menu, please refer to its own user manual.
Enter Click to confirm your selection / enter the menu.
Up / Down / Left / Right Click to move your selection up / down / left / right, or change settings.
Click to zoom in on the image to the largest / zoom out on the image to its
Zoom in / out max
original size.
Zoom in / out Click to zoom in / out the image.
Focus near / far Click to adjust the focus of the image.
Click to activate the auto function.
Before using it, you need to assign a specific function that will be enabled
Auto mode
when "AUTO" is clicked. For details, please refer to the user manual of the
PTZ camera.
Click to enter the PTZ preset point you want to see.
Preset point
QUICK START
DATE SETUP
SYSTEM
EVENT INFORMATION
ADVANCED CONFIG
SCHEDULE SETTING
GUI DISPLAY WITH USB MOUSE CONTROL
Click to set the status display, image settings, and date &
time.
Click to set the date display and daylight saving.
Click to set the system configurations.
Click to enter the event search menu.
Click to set CAMERA, DETECTION, ALERT,
NETWORK, SNTP, DISPLAY, RECORD, DEVICES,
DCCS, IVS & NOTIFY.
Click to set record timer and detection timer.
10