Dvr Power On; Date And Time Setting - Avtech AVC799B User Manual

CANERA
DETECTION
ALERT
NETWORK
DISPLAY
RECORD
DEVICES
DCCS
IVS
NOTIFY
EXIT

2.3 DVR Power On

This device should be operated only with the type of power source indicated on the manufacturer's label. Connect
the indicated AC power cord to the power adapter, and plug into an electrical outlet. The power LED will be on.
Note: Before the DVR is powered on, make sure the cameras are connected and power-supplied for the
detection of the camera video system to be correct.
Note: To ensure that your DVR works constantly and properly, it's recommended to use an UPS,
Uninterruptible Power Supply (Optional), for continuously operation.

2.4 Date and Time Setting

Before operating your DVR, please set the date and time on your DVR FIRST.
Note: Please DO NOT change the date or time of your DVR after the recording function is activated.
Otherwise, the recorded data will be disordered and you will not be able to find the recorded file
to backup by time search. If users change the date or time accidentally when the recording
function is activated, it's recommended to clear all HDD data, and start recording again.
Note: For the first time to use the DVR, please power it on for at least 48 hours continuously after the
date & time is set correctly. It helps to prevent DVR time from resetting after the disconnecting of
DVR power. If the DVR time resets after the disconnecting of DVR power, for example, caused by
a power outage, the battery might run out and please replace the battery as described in
"APPENDIX 6 DVR BATTERY REPLACEMENT" at page 61.
Right-click to enter the DVR password with the password keypad. The default administrator password is 0000.
The status will be changed from
and select "QUICK START"
GENERAL
TIME SETUP
EXIT
ADVANCED CONFIG
CH1 CH2 CH3 CH4 CH5 CH6 CH7 CH8 CH9 CH10 CH11
DEVICE
ID
PROTOCOL
RATE
(key lock) to
"TIME SETUP" to set the date & time.
QUICK START
DATE 2009 / NOV / 17
TIME 15 : 35 : 53
PTZ
000
NORMAL
2400
(administrator). Then, right-click to show the main menu,
7
CONNECTION AND SETUP