Mitsubishi Heavy Industries FDTC50ZHXV Technical Manual page 365

Installation of the receiver
1
Loosen the bolts which fix the panel and make a gap between the panel and the indoor unit
2
Put the wiring of the receiver through the opening.
3
Put the wiring on the notch on the control box so as not to be pinched by the control box and lid as shown below.
4
Connect the wiring to the terminal block provided in the control box. (Non- polarized)
5
Attach the receiver to the panel according to the panel installation manual.
6
Fix the wiring with the clamp so that the wiring do not contact the edge of control box's metal sheet.
7
Reattach the control box lid with 3 screws removed.
*Note: Make sure the wires not to be pinched by any other parts like panel, control box and indoor unit.
Terminal block in the indoor
unit control box
355
- -