Mitsubishi Heavy Industries FDTC50ZHXV Technical Manual page 206

Receivable range
(c) Installation preparation
1) Remove the air return grille.
Slide the stoppers (4 places).
2) Remove the side panels.
Take out the screws, then slide the side panels in the arrow direction to remove them.
3) Remove the suspension lug.
Take out the screws, then loosen the installation bolt.
Loosening
margin
8~12 mm
Lug for
suspension
4) Suspension bolt position
a) Using the paper pattern supplied as an accessory
as a criterion, select suspension bolt positions and
piping hole positions, then install the suspension
bolts and make holes for piping. After positioning,
remove the paper pattern.
5m
(Top view)
Receivable range
60°
60°
Side panel
Indoor unit
a) Please operate remote control unit switches with the unit faced
correctiy toward the indoor unit's receiver section.
b) Effective operation distance can vary with the luminance around
the receiver and the reflection from walls of the room.
c) When the receiver is exposed to intensive light such as from the
direct sun or a strong light, it may become operable only from a
short distance or unable to receive signals at all.
Take out the pins (4 or 6 places).
Side panel screw
(1 each on the left and right sides) (M4)
Suspension
lug screws (M4)
Suspension
lug mounting
bolt (M8)
198
- -
Filter
Pin
Lug for
suspension
Paper
pattern