Mitsubishi Heavy Industries FDTC50ZHXV Technical Manual page 250

7) Press SET button. (Fixing of the upper limit position)
7
The upper limit position is fixed and the setting position is displayed for two seconds.Then proceed to lower limit
position selection display.
[EXAMPLE]
(displayed for two seconds)
(shows current setting)
8) Press or button. (Selection of lower limit position)
7
Select the lower limit position of louver.
"position 1" is the most horizontal, and "position 6 " is the most downwards.
"position --" is to return to the factory setting. If you need to change the setting to the default setting, use "position --".
(the most horizontal)
(the most downwards)
(return to the default setting)
9) Press SET button. (Fixing of the upper limit position)
7
Upper limit position and lower limit position are fixed, and the set po-
sitions are displayed for two seconds, then setting is completed.
• After the setting is completed, the louver which was set moves from
the original position to the lower limit position, and goes back to the
original position again. (This operation is not performed if the indoor
unit and/or indoor unit fan is in operation.)
[EXAMPLE]
(displayed for two seconds)
10) Press button.
7
Louver adjusting mode ends and returns to the original display.
Caution
If the upper limit position number and the lower limit position number are set to the same position, the louver is fixed
at that position auto swing does not funtion.
ATTENTON
If you press RESET button during settings, the display will return to previous display.If you press
button during settings, the mode will be ended and return to original display, and the settings that have not been
completed will become invalid.
When plural remote controllers are connected, louver setting operation cannot be set by slave remote controller.
241
- -
Upper
position
Movable
range
Lower
position